+86 021 67109909     +86 18017809222
All Categories

Home > Products > Insulation Accessories > Insulate tube and cylinder

  • Insulating Cylinder HV SPC163 For Vacuum circuit breaker
  • Insulating Cylinder HV SPC163 For Vacuum circuit breaker

Insulating Cylinder HV SPC163 For Vacuum circuit breaker

Description:

Insulating Cylinder HV SPC163 For Vacuum circuit breaker

  • Product Description

Insulating cylinder HV SPC163 for vacuum circuit breaker

Item No: SPC163

Description:

VS1 (ZN63)-12 type Side installation indoor high voltage vacuum circuit breaker is Indoor high voltage switchgear, Applies to rated voltage 12kv, frequency 50Hz three-phase power system,Electrical protection and control as the use of vacuum circuit breaker as a result of the special advantages, in particular the need for frequent operation under the rated current or short-circuit current breaking many places.

Application

The variety of insulation and sensor listed in sample all adopt epoxy vacuum pouring technology for one-time molding, kinds of insulation pull rod, bushing, contact box, insulating cylinder and bell housing etc adopt APDA technology for molding (majority).while, some product adopt SMC,DMC instauration alkyd enlargement mode plastic for compacting molding. All the product are applied to 3.6~40.5KV mid-large volt switchboard, for some product and specification size owning special requirement, it could be designed and manufactured according to user demand.

The use of environmental conditions:

1. Ambient temperature: not higher than +40 °C, not less than -40°C

2. Altitude: not exceed 2000m.

3. Relative humidity: daily average of not more than 95%, month average of not more than 90%. Saturated vapor pressure daily average of not more than 2.2 × 103MPa, month average not more than 1.8 × 103MPa.

4. Earthquake intensity: not more than eight.

5. No fire, explosion hazard, serious filthy, chemical corrosion, as well as places of intense vibration.

 

Insulating cylinder HV SPC163 for vacuum circuit breaker

Item No: SPC163

Details

1. Radius of Upside area and the lower area is 2 and 0.4.
2. Lightning impulse withstand volt: 48kV.

3. The partial discharge quantity: less than 5pC
4.Tensile strength: more than 60MPa
5. Compressive strength: more than 160MPa
6. Bending strength: more than 115MPa
7. Impact strength: more than 10KJ/m2
8. Brinell hardness: more than 25HB
9. In the normal Insulation resistance: more than 10000MΩ

10. The insulating cylinder is made from Epoxy Resin by APG technology, the insulation cylinder without affecting of the mechanical and electrical property

Contact Us